Tecno Spark 8c KG5j FRP Bypass & Full Flash Using Test Points with Infinity CM2
Introduction:
In this comprehensive guide, we will walk you through the process of bypassing the FRP (Factory Reset Protection) and performing a full flash on the Tecno Spark 8c KG5j using test points and the Infinity CM2 tool. FRP lock is designed to protect your device from unauthorized access after a factory reset, but it can become a hindrance when you forget your Google account credentials. By following these step-by-step instructions, you can successfully bypass the FRP lock and perform a full flash on your Tecno Spark 8c KG5j device.
Important Notes:
Before proceeding with the FRP bypass and full flash process, it's essential to understand that this procedure will erase all data on your device. Ensure you have backed up all necessary data to avoid permanent loss. Additionally, this guide is intended for educational purposes only. We are not responsible for any damage or issues that may occur during the process. Proceed at your own risk.
Requirements:
1. Tecno Spark 8c KG5j device with a minimum of 60% battery.
2. USB cable and a Windows PC or laptop.
3. Infinity CM2 Dongle and software.
4. Correct firmware for the Tecno Spark 8c KG5j model.
5. Patience and attention to detail.
Step-by-Step Guide:
1. Install Infinity CM2 Software:
Ensure you have installed the Infinity CM2 software on your Windows PC. If you haven't done so already, download and install the latest version from the official Infinity CM2 website.
2. Download Firmware:
Locate and download the correct firmware for the Tecno Spark 8c KG5j model from a reputable source. Ensure that the firmware is compatible with your device.
3. Prepare the Device:
Power off your Tecno Spark 8c KG5j device and remove the battery (if possible). Identify the test points on the device's PCB; these will be used to establish a connection with the Infinity CM2 tool.
4. Connect the Device to PC:
Connect one end of the USB cable to your PC and the other end to the Tecno Spark 8c KG5j device without inserting the battery.
5. Enter EDL Mode:
Short the test points on the device's PCB and insert the battery while keeping the test points shorted. This action will put the device into Emergency Download (EDL) mode.
6. Detect the Device in CM2:
Open the Infinity CM2 software on your PC. Go to the "Read/Write" tab and select "Read Firmware." CM2 should detect your Tecno Spark 8c KG5j in EDL mode.
7. Flash the Device:
In the Infinity CM2 software, click on "Flash" and select the previously downloaded firmware file for your Tecno Spark 8c KG5j. Start the flashing process and wait for it to complete.
8. FRP Bypass:
After successful flashing, the device will reboot. Follow the on-screen instructions to set up the device until you reach the Google account verification screen. Now, you have bypassed the FRP lock.
Conclusion:
By carefully following the steps outlined in this guide, you should now have successfully bypassed the FRP lock and performed a full flash on your Tecno Spark 8c KG5j using test points with the help of the Infinity CM2 tool. Always exercise caution during the process and ensure that you have the correct firmware to avoid any potential issues. Remember, this guide is for educational purposes only, and we are not responsible for any damage caused during the process.
No comments: